How To Fit A Stereo To Your Caravan Or Camper

Share on facebook
Share on twitter
Share on linkedin
Share on email

Installing a new stereo is actually a fairly straightforward DIY project well within the wheelhouse of the average backyard caravan mechanic.

All you’ll need is an electric drill, jigsaw (or hole saw), 12V cabling, and the new stereo.

The caravan this unit was installed into was a vintage van which runs solely on 240V mains power, so we had to install a separate 40A DC power supply for this one. However, this isn’t necessary if your van uses 12V battery power, which most modern vans do.

It’s also important to note that if you’re working with 240V electricity, you’ll need a licensed electrician to perform or sign off on any electrical work.

1. MEASURE OUT A SPOT FOR THE STEREO

Measuring-out-a-spot-for-the-stereo-in-a-caravan

Find the right spot for the stereo and measure for the hole according to the unit’s dimensions. Be as accurate as possible, while allowing a small amount of space around the stereo as a margin for error.

2. DRILL HOLE IN THE CORNERS

Drilling-a-hole-in-the-corners-of-the-wall-to-fit-a-stereo-in-a-caravan

Once measured, drill a hole in each corner of the clearly marked space. This is to make it easier to see exactly where to begin and end cutting.

3. CUT OUT THE SPACE FOR THE STEREO

Cutting-out-the-space-for-the-stereo-in-a-caravan

Using the jigsaw, cut the space from (drilled) hole to hole. Make sure all corners are square and the stereo fits the space.

4. MARK AND DRILL THE HOLES FOR THE SCREWS

Marking-and-drilling-the-holes-for-the-screws-to-fit-a-stereo-in-a-caravan

Drill holes in the wall according to the size of the screws supplied with the stereo unit. Make the holes slightly larger than the screws to make sure they can move (if necessary) to line up. Before drilling, a good tip is to mark the holes and remove the stereo to ensure accuracy (inset).

5. SCREW THE STEREO INTO THE WALL

Screwing-the-stereo-on-the-caravan-wall

Drill screws in to secure stereo, making sure the screws have back plates on the other side of the wall. (You may need another person to hold the back plates in place.)

6. POSITION AND SECURE YOUR POWER SUPPLY

Positioning-and-securing-the-stereo-power-supply-in-a-caravan

Position and secure the power supply/inverter. This can be anywhere around the stereo, as long as it has at least a small amount of air flow and is close to a powerpoint. If a new powerpoint has to be installed, get a licensed electrician in for the job.

7. CONNECT THE POWER SUPPLY TO THE STEREO

Connecting-the-power-supply-to-the-stereo-in-a-caravan

Using a 12V cable, connect the power supply to the back of the stereo. If possible, it is a good idea to blank off any wires that aren’t being used so they don’t short out (right).

8. FIND A SPOT FOR THE SPEAKERS

Finding-a-spot-for-speakers-for-the-stereo-in-a-caravan

Find a spot and measure holes for the speakers before cutting the space with a hole saw (or jigsaw).

9. WIRE UP THE SPEAKERS

Wiring-up-the-speakers-for-the-stereo-in-a-caravan

Run wiring from the speakers back to the stereo, making sure you are following the correct polarity (negative to negative; positive to positive). Consult speaker instruction if you are not sure. Try to keep all leads unobtrusive and out of the way.

10. MOUNT THE SPEAKERS

Mounting-the-speakers-for-the-stereo-in-a-caravan

Fit and screw the speakers in place. Determine where the aerial needs to go and drill a small hole from the inside of the van (turn off power and be aware of wiring). Using the small hole as a guide, drill large hole from outside and run the cabling through.

11. MOUNT THE AERIAL

Mounting-the-aerial-for-the-stereo-in-a-caravan

Screw base to cladding and seal with silicone, then screw the aerial to the base and connect wiring to the stereo on the inside. (Use stainless steel screws rather than those provided with the aerial.)

Mounting-the-aerial-for-the-stereo-in-a-caravan-2

12. PLUG IN THE POWER AND TIDY UP LOOSE CABLES

Pluggin-in-the-power-and-tidying-up-loose-cables-for-caravan-stereo

Plug power supply to the powerpoint and tidy up any loose wiring and cables behind the unit.

RECENT ARTICLES

ebook library

ebook - Upgrade Your Caravan

Our collection of eBooks are a valuable resource for any novice or experienced caravan holiday-maker.

JOIN US

To receive regular towing hints, tips sign up to our newsletter today! Without A Hitch is the place you can turn to for up-do-date information.

For access to our collection of eBooks, simply sign up to Without a Hitch and we will send you access to our online library;

ALREADY SIGNED UP? ENTER YOUR EMAIL & WE'LL SEND YOU ACCESS TO OUR eBOOK LIBRARY

NEW TO WITHOUT A HITCH - JOIN US

To receive access to our eBook library, regular towing hints, tips sign up to our newsletter today! Without A Hitch is the place you can turn to for up-do-date information.